學人焊線做8字頭 (改良後photo p.4)

djaddy

19# micma
http://www.epemag.wimborne.co.uk/solderfaq.htm

Here's a summary of how to make the perfect solder joint.

   1. All parts must be clean and free from dirt and grease.
   2. Try to secure the work firmly.
   3. "Tin" the iron tip with a small amount of solder. Do this immediately, with new tips being used for the first time.
   4. Clean the tip of the hot soldering iron on a damp sponge.
   5. Many people then add a tiny amount of fresh solder to the cleansed tip.
   6. Heat all parts of the joint with the iron for under a second or so.
   7. Continue heating, then apply sufficient solder only, to form an adequate joint.
   8. Remove and return the iron safely to its stand.
   9. It only takes two or three seconds at most, to solder the average p.c.b. joint.
  10. Do not move parts until the solder has cooled.

micma

你係咪就咁焊上去?
有冇上左鍚係8字頭到先?
yazhou 發表於 2009-11-19 22:12

我分別上左錫係8字頭及線上先....之後焊接埋一起

micma

19# micma
http://www.epemag.wimborne.co.uk/solderfaq.htm

Here's a summary of how to make the perfect solder joint.

   1. All parts must be clean and free from dirt and grease.
   2. Try to secure  ...
djaddy 發表於 2009-11-19 22:13

我都好似差唔多呀...

juniorx

DIY好, Any improvement?

micma

DIY好, Any improvement?
juniorx 發表於 2009-11-19 22:25

我覺得畫面黑位黑左...整體實左...秋記姐姐話要兩星期run-in...

唔想整到我咁...秋記有成品買

djaddy

15A is good for beginners!

rlwk2009

做得差唔好見笑

重未買收縮膠包埋個8字頭
micma 發表於 2009-11-19 22:00

ching 好似上唔夠錫丫，下次兩邊都要先上多少少錫，然後至焊在一起

rlwk2009

是喔,又想問普通和冷凍的大概要幾錢啊?
mimi 發表於 2009-11-19 21:59

普通$2X，冷凍$5X

micma

ching 好似上唔夠錫丫，下次兩邊都要先上咗錫，然後至焊在一起
rlwk2009 發表於 2009-11-19 22:33

明白...下次落多d錫...thanks for your comment.

其實要唔要打開加番多d錫落去呀

micma

普通$2X，冷凍$5X
rlwk2009 發表於 2009-11-19 22:35

師兄...請問可唔可以睇下你嘅成品樣給我睇下鍚嘅份量呀...thanks